Cable Wiring Diagram for Tuner/Amp Output Phone Plug
2.2.3 EFFECTS LOOP The Effects Loop jack is designed for use with outboard effects such as compressors, delay units, or reverbs. A �Y� cord with one TRS 1�4�� connector to two 1�4� TS is required to use this function. This Effects Loop output jack can also be used to supply the audio feed for a sound card. Most computer sound cards are provided with a 1/8� (3.5mm) female stereo audio input jack. The ACOUSTI-Q�s signal can be sent to this connection by inserting a 1�4� (TS) plug into the Effects Loop. The Main (XLR) output is defeated if the 1�4� jack is fully inserted. To send a signal to both input channels of the sound card requires the 1/8� stereo plug to have the tip and ring connected to one another.
Sleeve Ring Tip Tip Sleeve
Ring
TIP = Output (Send) RING = Input (Return) SLEEVE = GND
Cable Wiring Diagram for Effects Loop Output TRS Plug
If the Main output of the ACOUSTI-Q is to be used to feed a computer�s sound card, this can be done by using a cable with a female XLR connector to a 1/8� (3.5mm) stereo plug. The correct wiring for this cable is � the shielding from Pin 1 (GND) of the XLR is connected to the sleeve connection of the 1/8� stereo plug, the wire from Pin 2 of the XLR is connected to the tip of the 1/8� plug and the wire from Pin 3 of the XLR is lifted (not connected). The mono output of the ACOUSTI-Q will now be available to the left channel of the computer�s sound card.
